Instructions For Installation - Vega VEGASWING 51 Operating Instructions Manual

Adhesive products
Inflowing medium
Flows
VEGASWING 51 • - transistor (PNP)
4.2

Instructions for installation

In case of horizontal mounting in adhesive and viscous products, the
surfaces of the tuning fork should be vertical in order to reduce build-
up on the tuning fork. The position of the tuning fork is indicated by a
marking on the hexagon of VEGASWING 51. With this, you can check
the position of the tuning fork when screwing it in. When the hexagon
touches the seal, the thread can still be turned by approx. half a turn.
This is sufficient to reach the recommended installation position.
In adhesive and viscous products, the surfaces of the tuning fork
should protrude into the vessel to avoid buildup. Therefore sockets for
flanges and mountings bosses should not exceed a certain length.
Fig. 5: Adhesive products
If VEGASWING 51 is mounted in the filling stream, unwanted false
measurement signals can be generated. For this reason, mount VE-
GASWING 51 at a position in the vessel where no disturbances, e.g.
from filling openings, agitators, etc., can occur.
To make sure the tuning fork of VEGASWING 51 generates as little
resistance as possible to product flow, mount the sensor so that the
surfaces are parallel to the product movement.
30 mm
(1.18")
4 Mounting
11