MZ 125 SX Repair Manual page 54

Shock Absorber
3.14.2 Side Stand
Attention!
Risk of injury!
The tension springs may jump away during removall
installation!
Wear protective goggles!
Removal
1. Remove the side stand switch.
2. Pull off the screw.
3. Slide through the sleeve with thorn.
4. Pull the side stand downward off the pivot bracket.
5. Disconnect the springs.
Installation
1. Connect the side stand to the springs and with the stand in
folded position, lift it onto the pivot bracket with the fork,
using some force.
2. Grease the sleeve well, insert the sleeve and screw.
3. Adjust the side stand switch with the nose of the switching
part in the hole of the side stand fork.
4. Install the side stand switch.
T .... A ..... +hi ... +i,..h+"".... h +h 1\.J1&:: ~,..
..
O'\A/C.
\Alith
l::;
1I.In"l Tho tt .r.... fho
I V \.IV ~'''''''' LI~.'~
"
HI • • v
VVILI , .. , •••
I ' "1 .,,'-'
screw approx. 90' back.
Only turn the screw while holding the nut still.
5. Function test of the side stand switch.
:J
50
05/02
MZ 125 SXlSM Repair Manual