UJL1
Lighting/Signal System
5. Unscrew the hexagon socket head screw, remove the
housing.
Installation
1. Insert the cable protector into the guide.
2. Screw on the housing.
3. Run the cable through the indicator light rod.
4. Connect the cable and insert the reflector.
5. Install the light emission lens.
6. Perform a function test.
3.5.3
Headlight Casing
Removal
1. Unscrew the two oval flange head screws of the headlight
fixing on both sides, remove the headlight (1) and pull off
the connecting cable from the bulb.
2. Dismount the turn indicators (2) on both sides.
Make certain that the tapping nut do not fall out of the
bracket of the rubber holders.
3. Pull the headlight housing from the front mud guard.
Installation
Install in reverse order.
Inspect the rubber holders of the headlight mask and replace, if
necessary.
1. Insert the headlight housing with the nose into the mud
guard.
2. Mont the turn indicators and the headlight.
3. Perform a function test and adjust the headlight
(see 3.5.4 "Adjusting the Headlight").
MZ 125 SXlSM Repair Manual
Tightening torque:
Oval fiange head screws:
Turn indicator pan-head screw:
05/02
6+
1
Nm
1.5+ 0 ,9 Nm
31