Spoke Fitting; General Procedure; Spoke Fitting Values For Sx - MZ 125 SX Repair Manual

I..J,jf
-1
Spoke Fitting
4.7 Spoke Fitting
4.7.1 General Procedure
1. Place rim and hub on a table, and have the spokes ready.
2. Place blocks of wood at least at 3 positions under the rim,
so that the rim is located at the right level to the hub.
3. Insert the spokes with the threads through the hub.
4. Slide the spoke nipples through the rim and screw the
spoke nipples to the spokes.
5. Tighten the spoke nipples cautiously.
Make certain that the rim always remains at a right angle to
the axle.
6. Mount wheel bearing and axle.
7. Check the eccentricity.
If the differences are too big, adjust the eccentricity via the
spoke nipples and check again.
4.7.2 Spoke Fitting Values for SX
y
MZ 125 SXJSM Repair Manual
Two different spoke types are used on the SX front wheel:
(1) Short spoke, 235 mm, 141", 18 pes.
(brake disc side)
(2) Long spoke, 277 mm, 144", 18 pes.
Spoke nipple DIN 74371 M3.5-6.4x18-c 2.0+ 0 . 5 Nm
Rim 1.85x21"
Front wheel hub, Bassano Grimeca company:
-X=25.5 mm
- Y = 47.5 mm
Position of eccentricity measurement
- A = lateral eccentricity at the rim edge: 0.5 mm
- B = vertical eccentricity at the rim edge:0.5 mm
Three different spoke types are used on the SX rear wheel:
(1) Short spoke, 172 mm, 168", 18 pes.
(2) Long spoke, 187 mm, 122", 9 pcs.
(brake disc side)
(3) Spoke, 184 mm, 122",9 Stk. (brake disc side)
Spoke nipple DIN 74371 M4x6.4x18-c, 2.5+
0 . 5
Nm
Rim 2.50x18" (Enduro)
Rear wheel hub, Bassano Grimeca company:
-X =33.3 mm
- Y =63.5 mm
Position of eccentricity measurement
- A = lateral eccentricity at the rim edge: 0.5 mm
- B = vertical eccentricity at the rim edge:0.5 mm
05/02
111