Tum Indicator Lights - MZ 125 SX Repair Manual

I.J..JJ J
Lighting/Signal System
3.5.2 Turn Indicator Lights
All four tum indicator lights are almost identical.
The difference is in the location of the water run-off notch on the
light housing and in the connection cable.
The water run-off notches must always face downward when
installed so that water can flow away.
Perform the same work steps for all four turn indicator lights.
Changing the bulb
Type:19/10-12 V/10 W
1. Unscrew the screw on the rear side.
2. Remove the light emission lens.
3. Turn the bulb slightly to remove it.
4. Check the terminals and clean if necessary.
The ends of the cable must be clean and tightly clamped in.
5. Insert the new bulb, turning slightly, and check that it sits
tightly.
6. Install the light emission lens.
Turn indicator light housing
Removal
1. Unscrew the cable from the negative pole on the battery.
2. Remove the light emission lens.
3. Note the connection locations.
Pull out the cable and remove the reflector.
4. Pull the cable out of the light housing through the indicator
light rod.
30
05/02
MZ 125 SXlSM Repair Manual