Clutch Activation Lever - MZ 125 SX Repair Manual

u:.tL1
Clutch
The basic adjustment is performed at the clutch basket.
6.4.2 Clutch Activation Lever
Removal
1. Remove starter (see 5.11 "Starter").
2. Remove pinion cover.
3. Disconnect the bowden cable at the counter bearing and
clutch activation lever (1) on the engine.
4. Remove the pUll-back spring (2).
5. Unscrew the screw (3) for the clutch activation lever.
6. Pull the shaft completely out of the housing, remove spring.
7. Remove the shaft seal ring and needle bush and replace if
necessary.
The shaft seal ring is destroyed by removing it!
Note:
The sliding bearing for the shaft of the clutch activation lever can
only be replaced on a dismantled engine.
Installation
1. Insert needle bush and seal ring.
2. Insert the clutch activation lever with spring at an angle of
is''.
3. Screw in the screw for the clutch activation shaft with screw
locking agent at medium tightness.
4. Connect the bowden cable at
tti~!utch
connection lever
and clutch lever.
5. Return pull-back spring.
6. Perform a function test.
MZ 125 SXlSM Repair Manual
Tightening torque:
Screw of clutch activation shaft:
05/02
5+
2
Nm
145