MZ 125 SX Repair Manual page 107

!..J5.. C1
Rear Wheel
Installation
1. Place the rear wheel between the swingarms.
2. Mount the chain.
3. Slide the axle into the chain adjuster from the right.
4. Insert the adapter plate.
5. Slide the axle through the adapter plate and wheel, screw
on the axle nut.
6. Adjust the chain slack
(see 4.5.2 "Adjusting the Chain Slack").
The cover plate of the chain adjuster must sit tight against
the swingarm on both sides.
Note:
Place a 4 mm spike between chain and chain plate.
Turn the wheel a
Y.
to % turn so that the cover plate of the chain
adjuster sits tight against the swingarms.
Important!
Do not apply force. Otherwise the chain/chain plate may get
damaged.
7. Tighten the axle nut, observe the specified torque.
8. Inspect the wheel tracking.
9. Expand the brake pads.
10. Install the brake caliper over the brake disc.
11. Observe the specified torque and use screw locking agent.
12. Operate the foot brake lever until the you feel the pressure
point and the braking effect sets in.
13. Test the smooth rotation of the wheel.
MZ-125 SX1SM Repair Manual
Tightening torque:
Axle nuts:
05/02
100+
10
Nm
103