Precise Instrument DAT 400 Technical Manual page 33

FUN
ParaN In-oUt
SET
NodE 1
0
SET FUN
Hyst-1
0
SET FUN
t1NEr1
0
SET FUN
dELay1
0
SET FUN
NodE 2
0
SET FUN
Hyst-2
0
SET FUN
t1NEr2
0
SET FUN
dELay2
0
SET FUN
tEst1n
0
SET FUN
tstoUt
0
SET FUN
tEst1n
FUN
SEr1aL
The display shows the inputs status.
SET
PRG
0 = input disabled
1= input activated.
Select Value
PRG
PRG
The input 1 corresponds to the 1
Select Value
PRG
Enable and disable the inputs to check the corresponding state on
Select Value
the display. During this procedure, the normal function of the inputs
PRG
Select Value
PRG
is not active. Use this procedure only to check the hardware.
Enter Value
PRG PRG
tstoUt
The display shows the outputs status.
Enter Value
PRG
PRG
0 = output disabled, 1= output activated.
Enter Value
PRG PRG
The input 1 corresponds to the 1
During this procedure, the LEDs reflect the state of the outputs. To set
Select Value
PRG
the digits, use the keys as for the numeric settings.
PRG
Select Value
During this procedure, the normal function of the outputs is not active.
PRG
Select Value
Use this procedure only to check the hardware.
PRG
Select Value
PRG
Enter Value
PRG PRG
Enter Value
PRG
PRG
Enter Value
PRG PRG
Read and
PRG 0
change status
Read and
PRG 0
change status
LOGIC INPUTS TEST PROCEDURE
LOGIC OUTPUTS TEST PROCEDURE.
value on the left.
st
value on the left.
st
Page 31