Input/Output Parameters - Precise Instrument DAT 400 Technical Manual

FUN
ParaN In-oUt
SET
NodE 1
0
SET FUN
Hyst-1
0
SET FUN
t1NEr1
0
SET FUN
dELay1
0
SET FUN
NodE 2
0
SET FUN
Hyst-2
0
SET FUN
t1NEr2
0
SET FUN
dELay2
0
SET FUN
tEst1n
0
SET FUN
tstoUt
0
SET FUN

INPUT/OUTPUT PARAMETERS

NodE 1
FUN
SEr1aL
Select 4 operation criteria of the setpoint 1 in sequence:
SET
PRG
NET
GROSS
Select Value
PRG
PEAK
PRG
Select Value
Default: GROSS
PRG
Select Value
Comparison with the net weight, gross weight or the peak. In this
PRG
last case, the comparison is made with the last peak value acquired,
Select Value
PRG
even when the peak function is not active.
Enter Value
PRG PRG
N.O.
N.C.
Enter Value
PRG PRG
Default N.O.
POS.
Enter Value
PRG PRG
NEG.
Default: POS
Select Value
PRG
NORML
PRG
Select Value
STABL
PRG
Select Value
Default: Norml
PRG
Select Value
PRG
Hyst-1
Enter Value
PRG PRG
Hysteresis value than the setpoint value set.
Value: from 0 to 999
Enter Value
PRG
PRG
Default: 2
Enter Value
PRG PRG
t1NEr1
Read and
Value of time, in tenths of a second, during which, when the weight
PRG 0
change status
value set is overcome, the output relative to setpoint 1 remains
enabled.
Read and
PRG 0
change status
After this time, even if the weight value is still above the setpoint, the
output is automatically disabled.
The function is not activated if the programmed time is equal to zero.
Value: from 0 to 999
Default: 0
dELay1
Value of time, in tenths of a second, after which, when the weight va-
lue set is overcome, the output relative to setpoint 1 remains enabled.
The function is not activated if the programmed time is equal to zero.
Value: from 0 to 999
Default: 0
SETPOINT 1 OPERATION MODE
The relay output is active in Net Weight mode
The relay output is active in Gross Weight mode
The relay output is active in Peak mode
The relay 1 is normally open
The relay 1 is normally closed
The output is operating with positive weight
The output is operating with negative weight
Output 1 is active with unstable weight
The output is active with stable weight
HYSTERESIS OF THE SETPOINT 1
SETPOINT 1 TEMPORIZATION
SETPOINT 1 DELAY
Page 29