Configuration Mode Adaptation Adap; Control And Display Elements In The Configuration Mode Onpa - Siemens SIPART DR21 Manual

5 Operation
5.4 Configuration modes
2
Setpoint w
1
Setpoint x
3
Parameter
value
9
Parameter
name
tF, vv... c1...c7
Figure 5-3

Control and display elements in the configuration mode onPA

5.4.3

Configuration mode adaptation AdAP

This mode only appears in the selection mode S48 > 0 (with adaptation). The Enter function to
the AdAP configuration mode is only possible when the controller is in manual mode. For this
the structure switch S51 must be ≠ 1 (see structure switch list, table 5-5, page 172). In the
parameterization mode AdAP, the controller influences the process online (but in manual opera-
tion).
A distinction is made between 4 different states in the AdAP configuration mode
- Pre adaptation,
- During adaptation,
- Aborted adaptation,
- Post adaptation
In pre- and post-adaptation the digital displays and the keys are used for the parameter display
and setting as is the case in the parameterization mode and structuring mode onPA or oFPA.
The complete process image as described in chapter 5.2, page 150 is displayed during adapta-
tion.
In the case of aborted adaptation the error message flashes in the digital w/xdisplay (3). The
error messages are acknowledged with the Enter key (11) (see figure 5-5, page 160).
156
SIPART DR21
PV SP
X W
C
100
ADAPT
A1
A2
SP-W
50
A3
A4
0
W
X
OUT-Y
SIEMENS SIPART DR21
7 8
no function
17
Internal LED: current status
16
Exit key ↗ : Return to selection-
mode after onPA
18
Exit LED: flashes
19
Adaptation LED: off
15
Adjustment of parameter
value with rapid action
14
12
Manual LED: current status
11
Enter key ↗ : no function
13
Enter LED: off
6
Shift key: no function
4, 5
C73000-B7476-C143-08
Manual
SIPART DR21