Table of Contents
Advertisement
Installing the unit
Installation
1 . Open the wired remote controller by pushing up the top cover of the remote controller while holding the rear cover
firmly . The wired remote controller opens in the way of slide .
2 . Install the rear cover of the wired remote controller on the wall with the supplied screws . After that, arrange the power
cables on rear side of the front cover .
3 . Connect the orange and brown wires from the wired remote controller to the power cable (V1, V2) of indoor unit .
Connect the red and black wires to the communication cable (F3, F4) of indoor unit .
f Terminal type cable connection
f
Power cable
(V1, V2)
4 . Reassemble the wired remote controller .
When you reassemble the wired remote controller, match the grooves on the left side .
• When using an extension cable, make sure that the communication cable and the power cable is installed
separately . (If not, it may cause malfunction of the wired remote controller . )
CAUTION
• Power cable of the wired remote controller(V1,V2) should be connected to the one indoor unit only .
6
EHS Control unit_MIM-E03@_IM_E_34413-2.indd 6
More than
More than
60mm
30mm
Screw hole
Rear cover
❋ ❋ Before fixing the rear cover, clear
30mm of space on the top and
60mm on the right side .
Communication cable
(F3, F4)
Indoor unit
Multi function
wired remote
controller
❋ ❋ Fasten the screw in the
screw hole .
Front cover
2012-04-05 오후 1:19:56
Advertisement
Table of Contents
