Honda Miimo HRM310 Owner's Manual page 63

Message
Outside loop The lawn mower exited the boundary
wire.
Blade motor The temperature of the blade motor is
or exceeds 185°F(85°C).
temp high
Obstruction
An obstruction is being detected, or
the sensor detects something.
detection
Obstruction Obstruction sensor is inactive, or there
is an object interrupting the sensor.
sensor
Excessive tilt
The lawn mower is in an excessively
tilted area.
Mower lifted The cover has been lifted by
something, e.g. a stone.
Upside down
The lawn mower is upside down.
Battery capacity The battery does not charge enough.
reduced
Battery capacity The battery does not charge enough.
low
No boundary The lawn mower does not detect the
boundary wire signal.
signal
Area signal lost The lawn mower does not detect the
boundary wire signal.
Contact your dealer if you cannot solve your problem using the troubleshooting displayed on the screen.
Area sensor
Battery Error
Battery temperature
Blade motor
Blade motor blocked
Blade motor relay
Charging control
Clock
Cause
Move the lawn mower into the work area.
Check the power supply of the docking station.
Check if the boundary wire connectors are correctly
connected.
If the message does not disappear, check if the
boundary wire connectors are correctly connected,
and check if there are no similar lawn mowers in the
area.
If the message still does not disappear, contact your
dealer.
Leave the power ON and the control panel cover
open, and wait 15 to 30 minutes until the message
disappears. If the message does not disappear,
contact your dealer.
Enter the PIN so that the message disappears. If the
message does not disappear, contact your dealer.
Fully move the main cover in order to check sensors
can be activated.
Shake : Not possible to recover
Turn off : Not possible to recover
If "Obstruction sensor" message remains, check
around and underneath the cover for any objects, like
chips, dust or small toys, then remove it or contact
your dealer.
Place the lawn mower on a fl at surface, and enter the
PIN so that the message disappears. If the message
does not disappear, contact your dealer.
Enter the PIN so that the message disappears. If the
cover is heavily damaged or the message does not
disappear, contact your dealer.
Place the lawn mower on a fl at surface, and enter the
PIN so that the message disappears. If the message
does not disappear, contact your dealer.
Increase the remaining capacity of homing. See
"Homing setup" (M page 41). If the message does not
disappear, contact your dealer.
Check a power supply of docking station. See "Test
start points" (M page 44). If the message does not
disappear, contact your dealer.
Check if the boundary wire connectors are correctly
connected. If the message does not disappear,
contact your dealer.
Communication Error
Data memory Error
Display Unit Error
Lift sensor
Manual stop
Motor ECU Error
Motor sensor Blade
Motor sensor L
Solution
Motor sensor R
Rollover sensor
Tilt sensor
Wheel motor
Wheel motor blocked
Wheel motor relay
Yaw sensor
Messages
61