Honda Miimo HRM310 Owner's Manual page 34

Setting the lawn mower operation
Distance from the boundary wire when the lawn mower goes toward the
mowing start points:
The lawn mower moves between the boundary wire and the specifi ed value at random as it goes toward the
mowing start point.
Passage width sample table
Setup level
0
1
2
3
4
5
6
7
8
9
10
11
12
The angle at which the lawn mower deviates from the boundary wire:
The lawn mower travels to this location along the boundary wire, and then turns away from the boundary wire
to start mowing.
You can confi gure the angle (range) at which the lawn mower deviates from the boundary wire when it starts
mowing as below:
TIPS Use the exit angle to let the lawn mower reach the mowing areas directly instead of using long wire
exit locations.
32
Low value
High value
Passage width NOTE:
- The fi eld strength varies depending on the length of the
4 in. (10 cm)
boundary wire. The fi eld becomes weaker with a longer
10 in. (25 cm)
boundary wire, and stronger with a shorter boundary wire.
12 in. (30 cm)
- When the value is high (by avoiding moving along the same
14 in. (35 cm)
path), you can avoid creating wheel tracks in the grass.
- The numerical values of this table are for reference to return the
16 in. (40 cm)
lawn mower to the docking station along a straight line.
18 in. (45 cm)
- The numerical values may differ depending on the actual
20 in. (50 cm)
conditions.
24 in. (60 cm)
28 in. (70 cm)
32 in. (80 cm)
36 in. (90 cm)
40 in. (100 cm)
44 in. (110 cm)
Start point
Start
Range
End
Narrow passage
Low value
Value is too high
NOTE:
- When the value is too high, lawn mower
may not pass through narrow passage.
Line
Boundary wire