Moving The Meat Drawer And Cover I; Changing The Light Bulb; Adjusting The Refrigerator Shelves - Whirlpool ET14AK Use & Care Manual

Moving the meat drawer and cover...
TO
remove:
The meat drawer and cover can be removed for 1. Slide meat drawer out to stop.
cleaning and moved to another shelf, if desired.
2. Lift the front of the meat drawer.
Remove the meat drawer first.
3. Slide drawer the rest of the way out.
4. To remove the cover, lift it straight up and out.
To replace:
1. Fit notches of cover sides over center shelf
support.
2. Lower cover into place.
3. Fit edges of drawer into supports on cover.
4. Slide meat drawer into place.
i,:.
e _ . A-:.* y,
Changing the light bulb...
1. Reach behind the control console to find bulb.
2. Remove bulb.
3.
ReDlaCe
with a 40-watt aooliance bulb.
Adjusting the refrigerator shelves...
To remove the shelf:
1. First, remove food from shelf.
2. Slide shelf straight out to stop.
GUIDE STOP
3. Lift front, slide shelf the rest of the way out. SHELF STOP
To replace the shelf:
1. Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf in until it clears guide stops.
!w ' SHELF GUIDE
Removing crispers and crisper cover...
LIFT THE FRONT, THEN THE BACK.
\
To remove the crispers:
1. Slide crisper straight out to stop, lift front, then
slide the rest of the way out.
2. Replace in the reverse order.
To remove the cover:
1. Lift front and remove the cover support.
2. Lift out cover by pulling up and out.
To replace the cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab to-
wards the front. NOTE: If support needs adjust-
ment, turn base right to raise, or left to lower.
PiJU OUT TO STOP. LIFT
THE FRONT AND PULL AGAIN.