Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET14AK Use & Care Manual

No-frost refrigerator- freezer
Hide thumbs

Advertisement

Table of Contents
Install properly...
I
.
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm) between the re-
frigerator condenser on the back and the wall.
3. Allow
Y2
inch (1.25 cm] on each side of the re-
frigerator for ease of installation.
4. If the refrigerator
is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be ooened wider.
Level refrigerator-freezer...
WER
1. Keep the 4 bolts that hold refrigerator in ship-
ping crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes
at the bottom
corners
of refrigerator.
Roll
refrigerator into place.
3. Lower legs just enough to lift rollers off floor.
4. Adjust each until the refrigerator won't rock.
5. Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
6. Check with level,
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside
labels
before
using the re-
frigerator. To remove any remalning
glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area
with liquid
hand
dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol
or flammable
or
toxic solvents, such as acetone,
gasoline,
car-
bon tetrachlorlde,
etc. These can damage
the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet tastened under
the retrlaerator
at the front.
Clean it...
jq/
Clean your refriger-
ator before using it.
See cleaning
instruc-
'
tions on page 8.
f
Plug it in...
3-PRONG
GROUNDING
TYPE WALL RECEPTACLE
REFRIGER
POWER CORD
GROUNDING
PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly
grounded
electrical
supply
is
required. It is recommended
that a separate cir-
cuit serving only this appliance
be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual
electrical
requirements
and grounding
instruction sheet in your literature
package.
4

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool ET14AK