Miele PW 6101 Programming Instructions Manual page 40

Chip cards
Dispensing
This menu is used for copying dispensing
data from a card into the control unit.
Existing dispensing data is only overwritten
after another confirmation to do so.
Dispensing data is only copied from
programmes where the programme number,
name and M.Nr match. The M.Nr of the
programme is not deleted after changing
dispensing data.
Data to control unit ~ Dispensing
Dispensing: 13 : 40 10.06.04
^ After pressing the rotary dial the following
message will appear in the display:
Data to control unit ~ Dispensing
Overwrite existing data?
^ After pressing the "Save" S button the
following message will appear in the
display during the data transfer process:
Data to control unit ~ Dispensing
If it was not possible to copy all dispensing
data from a card into the control unit, the
following message will appear in the display
after transferring the data:
Data to control unit ~ Dispensing
Insufficient memory!
If copying does not work as described
above the following message will appear in
the display for 5 seconds:
Data to control unit ~ Dispensing
Data transfer not possible
40
S
D
Programme
This menu is used for copying one or more
programes from a card into the control unit.
It will overwrite existing programmes in the
control unit.
^ After making your selection the following
appears in the display:
Data to control unit ~ Programme
Programme: 13 : 40 10.06.04
^ The following will appear in the display
A
after you have pressed the rotary dial:
Data to control unit ~ Programme
1 Cottons
2 Cottons
Selection choice: - all programmes on the
A
card.
^ Press the rotary dial to highlight or
deselect a highlighted programme. If you
want to copy all programmes present to
the card press the 1-999 button.
After making your selection and pressing the
"Save" S button the display will show the
data relating to the target programme place
A
in the control unit.
The first free programme place in the control
unit will appear from which the selected
programmes on the card will be saved to.
Data to control unit ~ Programme
Target prog. number
Total Programme: 5
A
^ After entering your selection and pressing
the "Save" S button the data transfer will
be carried out.
A
A
90 °C
e
60 °C
A
1-999
11
S A
M.-Nr. 06 533 430