Uwatec S600 Configuration A Repair Manual page 5

Hold down the lever and remove the air
barrel from the case.
Hold down the lever and remove the air
barrel from the case.
Hold down the lever and remove the
plug from the end of the air barrel.
Then remove the air barrel itself from
the case.
CAUTION: Remove the plug first to
avoid scratching the sealing surface on
the case.
Remove the cracking effort adjustment
knob from the air barrel.
Remove the decal from the cracking
effort adjustment knob. This will allow
access to the balance adjustment
mechanisms.
Remove the o'rings from the cracking
effort adjustment knob.
2003 SCUBAPRO
Important note: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
SCUBAPRO S600-S550 SECOND STAGES
TOOLS
NEEDED
TOOLS
NEEDED
TOOLS
NEEDED
No tools needed
this step
No tools needed this
step
No tools needed this
step
5