Arctic Cat VLX 70002017 Service Manual page 85

CF688
5. Slowly disconnect the fuel hose connector from the
fuel rail.
! WARNING
Gasoline may be under pressure. Place an absorbent
towel under the connector to absorb any gasoline spray
when disconnecting.
CF730A
6. Remove the screw securing the throttle actuator
cover to the throttle body; then remove the cover.
CF732A
7. Loosen the outer jam nut securing the throttle cable
to the throttle body.
8. Remove the throttle cable from the actuator arm;
then route the cable out of the way.
9. Remove the MAP sensor (A), fuel injector connector
(B), ISC connector (C), and TPS connector (D).
84
CF733A
10. Loosen the clamp securing the throttle body to the
intake manifold flange. Remove the throttle body.
CF684A
11. Remove the cap screws securing the intake manifold
flange to the cylinder head. Account for an O-ring.
12. Use tape to cover and seal the intake opening.
CAUTION
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the engine
is turned over or started.
INSTALLING
1. Place a new O-ring onto the intake pipe; then posi-
tion the pipe onto the engine and secure with two cap
screws.
2. Using the alignment markings, install the intake pipe
boot then the throttle body. Tighten the clamp
securely.
CF694A
3. Connect the throttle cable to the throttle body and
adjust throttle cable free-play (see Throttle Cable
Free-Play); then connect the fuel hose.