Arctic Cat VLX 70002017 Service Manual page 38

CF676B
24. On the right side, disconnect the stator coil and
crankshaft position sensor connectors.
25. Disconnect the coolant temperature sensor connector
from the sensor.
26. Remove the engine mounting through-bolts. Account
for all mounting hardware.
CD809
27. Raise the rear of the engine enough to allow the rear
output flange to clear the output flange joint. Block
the engine up in this position.
CD811
28. Remove the first small boot clamp; then remove the
output flange and driveshaft from the rear drive cou-
pler.
CF728A
CD813
29. Remove the block from under the engine and lower
the engine; then remove the boot clamp from the
front output drive yoke.
30. Move the engine to the rear enough to allow the front
driveshaft to clear the front output yoke. Account for
the spring; then move the engine forward and to the
left. The engine will come out the left side of the
frame.
CD818
CD773
37