Arctic Cat VLX 70002017 Service Manual page 111

16. Loosen the two jam nuts (A) securing the four wheel
drive selector cable housing to the bracket. Remove
the four wheel drive tensioner spring (B) from the
selector shaft (C).
NOTE: Record the set length of the four wheel drive

cable housing for assembly purposes.
CF738A
17. Remove the two cap screws securing the four wheel
drive cable bracket to the front differential.
CF737A
18. Release the two front output shaft boot clamps.
XR343
19. Free the differential assembly from the frame; then
shift the differential assembly forward enough to dis-
engage the front driveshaft from the output yoke.
110
CD857
20. Place the differential on its right side; then remove it
from the frame.
Disassembling Input Shaft
NOTE: This procedure can be performed on a rear

gear case; however, some components may vary from
model to model. The technician should use discretion
and sound judgment.
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
GC004A
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring.
Note the location of all the components for assem-
bling purposes.
GC015