Arctic Cat VLX 70002017 Service Manual page 61

6. Remove the fixed drive face from the drive clutch
assembly.
7. Remove all cap screws securing the inner clutch
cover. Note the location of the different-lengthed cap
screws for installing purposes. Five cap screws are
located outside of the mating surface of the two
clutch covers. Two are located below, and three
located in front of the cover. Using a rubber mallet,
carefully remove the cover. Account for two align-
ment pins in the locations shown. Remove the gas-
ket.
H1-026
CAUTION
Care must be taken when removing the cover so the
cover gasket is not damaged.
H1-029B
NOTE: For steps 8-13, refer to illustration

H1-029A.
 NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
60
KEY
A. Oil Pump Driven Gear
B. Oil Pump Drive Gear
H1-029A
8. Using a hydraulic press, remove the clutch housing
assembly from the clutch cover. Account for the
right fixed drive spacer and an O-ring inside the
fixed drive spacer.
CF085
CC596
NOTE: Account for and inspect the clutch housing seal.

C. Clutch Shoe Assembly
D. Final Drive Carrier Bearing
Housing