Back Panel Cover - Electrolux ENV06 Service Manual

13.11 Back panel cover

1. Remove the worktop (see paragraph).
2. Unfasten the three screws (1) fixing the back
panel guard (made of plastic) at the centre.
3. Use a screwdriver to release the hooks that
fasten it on the outside. (2)
4. Unfasten all perimeter screws fixing the back
panel cover.
The figures show a conductivity sensor tumble dryer with rear brush; in machines that are not fitted with a
rear brush the procedure is exactly the same.
ADL 2010 / 01 46/57 599 72 63-27