Electrolux ENV06 Service Manual page 38

E62
Heating unit power relay faulty.
E63
Heating unit automatic reset thermostat triggered.
E64
Heating element thermostat.
E71
NTC1 probe malfunction.
E82
Selector malfunction in OFF position.
E83
Incorrect selector positions.
E93
Appliance configuration error.
E94
Drying cycle configuration error.
E97
Inconsistency between selector and cycles.
Appliance power supply frequency
EH1
outside limits.
EH2
Power supply voltage too high.
EH3
Power supply voltage too low.
ADL 2010 / 01
Heating unit faulty.
Faulty wiring.
Main circuit board faulty.
Thermostat faulty (replace heating unit).
Heating unit faulty.
Faulty wiring.
Main circuit board faulty.
Heating element thermostat faulty.
Faulty wiring.
Main circuit board faulty.
NTC1 probe faulty.
Faulty wiring.
Main circuit board faulty.
Circuit board wiring.
Board faulty
Circuit board wiring.
Board faulty.
Bad EEPROM configuration.
Main circuit board faulty.
Bad EEPROM configuration.
Main circuit board faulty.
Configuration error.
Problem with the power supply network
(incorrect/disturbed).
Main circuit board faulty.
Problem with the power supply network
(incorrect/disturbed).
Main circuit board faulty.
Problem with the power supply network
(incorrect/disturbed).
Main circuit board faulty.
38/57
Forced cooling cycle
Turn the power supply to the heating unit off.
If the problem ceases, the alarm will be
stored and the cycle will continue. If the fault
persists after attempting to repower the
appliance a few times, the alarm E62 is
triggered.
Forced cooling cycle
Cycle blocked
Cycle blocked
Cycle blocked
Cycle blocked. If the power supply becomes
stable again before the time-out, the cycle will
restart.
Cycle blocked
Cycle blocked. If the power supply becomes
stable again before the time-out, the cycle will
restart.
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
599 72 63-27