Chapter 11: UniFi Switch Details
•
PoE
All ports are set to auto-sensing PoE+ by default.
-
Off
Disable PoE.
-
24V Passive
Select this option to power devices that
support 24V passive PoE.
Note:
Before activating 24V passive PoE, ensure
that the connected device supports PoE and the
supplied voltage.
-
PoE+
802.3at/af devices can be plugged in and
automatically receive PoE.
•
Networks/VLANs
Select the appropriate network or
VLAN, or select Disabled to disable this port. The default
is All.
•
Advanced Options
Click the icon to display additional
options.
Operation
•
Select the operation mode for this port.
Switching, Mirroring, or Aggregate. Proceed to the
appropriate section.
Switching
-
Switching
The default mode.
88
•
Link Negotiation
Keep the default, Auto, or select
Manual to specify the duplex and speed:
Full Duplex
•
(Available for RJ45 ports only.)
Full-duplex transmission is enabled by default.
•
Link Speed
For RJ45 ports, select the appropriate
speed: 1000 Mbps, 100 Mbps, or 10 Mbps. For
SFP+ ports, select the appropriate speed: 10 Gbps
or 1000 Mbps. For SFP ports, select 1000 Mbps.
-
Isolation
Select this option to create a Private VLAN
(Virtual Local Area Network). Isolated ports cannot
communicate directly with each other.
-
Storm Control
Monitor the unicast, multicast, and/or
broadcast traffic for this port. If the specified type
of traffic on this port exceeds the threshold rate you
specify, then the UniFi Switch drops the excess traffic.
•
Unicast
Select this option to monitor unicast traffic.
Enter the threshold value in packets per second.
•
Multicast
Select this option to monitor multicast
traffic. Enter the threshold in packets per second.
•
Broadcast
Select this option to monitor broadcast
traffic. Enter the threshold in packets per second.
Apply
Click Apply to save changes.
•
•
Cancel
Click Cancel to discard changes.
Mirroring
UniFi Controller User Guide
Ubiquiti Networks, Inc.