Chapter 11: Unifi Switch Details; Properties - Ubiquiti UniFi User Manual

UniFi Controller User Guide
Chapter 11: UniFi Switch
Details
A UniFi Switch hyperlink opens the UniFi Switch's Details
window either in the Properties panel or as a separate
popup window. You can always dock this window in the
Properties panel or detach it as a separate window.

Properties

The Properties panel appears on the right side of the
screen. Information about each selected device appears as
a popup within this panel.
Remove All Click to close the Properties panel.
Collapse All Click to collapse all of the popups
to rows.
The top of the popup remains and displays the following:
• Display Click to display the device information.
• (icon) Displays the icon of the device (the icon will vary
depending on the model).
• (status) Displays to indicate the device status.
- Pending Approval A solid orange circle
the default state, available for adoption.
- Connected A solid green circle
managed connection.
- Managed by Other A solid gray circle
that the device is not in the default state but not
controlled by the current UniFi Controller.
Ubiquiti Networks, Inc.
indicates
indicates a
indicates
- Disconnected A red warning icon
connection.
• Name/MAC Address Displays the device name or MAC
address of the device.
• Restart Click to restart the selected device.
• Locate Click to flash the LED on the device and the
device icon on the Map tab so you can locate it. The LED
will flash until the Locate button is clicked again. (The
icon on the Map tab will flash three times and stop.)
• Upgrade Click to upgrade the device. (This icon
does not appear if an upgrade is not available or there
are pending changes.)
• Undock from Properties Panel
same information in a separate popup screen that can
be moved anywhere within the browser screen.
• Close Properties Click
Hide Property Panel
Click
but allow the device popups to remain accessible from
this panel. Click the properties
The upper part of the detached popup screen has an icon
for each port.
Indicates a 10/100 Mbps connection.
Indicates a 1 Gbps (1000 Mbps) connection.
Indicates a 10 Gbps connection.
Indicates 1 Gbps (1000 Mbps) connection with PoE.
Indicates the connection is disabled (no network or
VLAN is enabled).
Indicates no connection (the network or VLAN is
enabled, but the port is not in use).
Indicates STP blocking.
Indicates mirroring mode.
Place your cursor over a port to view details.
• Port Displays the port number.
• Name Displays the name of the port.
• Status Displays the connection speed and duplex mode.
• TX Displays the amount of data transmitted.
• RX Displays the amount of data received.
• PoE (Not applicable to the SFP ports.) Displays the PoE
setting:
- Off PoE is disabled.
24V Passive
- 24V passive PoE is enabled.
- __W Power output is displayed in watts.
- PoE+ 802.3at/af devices can be plugged in and
automatically receive PoE.

Chapter 11: UniFi Switch Details

!
indicates no
Click to display the
to close the device popup.
to hide the Properties panel
icon to re-open it.
85