Changing The Light Bulb - Whirlpool ET14HJXDN00 Use And Care Manual

Table of Contents

Advertisement

Solvina
common
ice maker
Droblems
I
PROBLEM
POSSIBLE CAUSE/SOLUTION
Ice crescents attached
l
This is normal. They break apart easily. Shake bin occasion-
at corners
ally to keep cubes separated.
Ice maker will not
l
ON/OFF lever is in the OFF (up) position. Lower lever to the
operate or Ice Is not
ON (down) position.
made fast enough
l
Freezer is not cold enough. Adjust temperature control and
wait 24 hours.
Off-taste or odor in ice
l
New plumbing connections can cause discolored or off-
flavored ice. Discard the first few batches of ice.
l
Cubes are stored too long. Throw them away and make a
new supply.
l
Foods in freezer are not wrapped properly. See "Food
Storage Guide" on pages 18 and 19.
l
Freezer and ice bin need to be cleaned. See pages 14
and 15.
Changing
the light
bulb
Electrical Shock Hazard
Before removing a light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the refrigera-
tor at the main power supply. Turning
the Temperature Control to the OFF
position does not disconnect the
refrigerator from the power supply.
Failure to do so could result in electri-
cal shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power
supply.
2. Reach behind the Control Panel to
remove bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: Not all commercial appliance bulbs
will fit your refrigerator. Be sure to replace a
bulb with one of the same size, wattage and
shape.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et14hjydn00Et14hjydw00Et14hjxdw00

Table of Contents