Provisioning Data Circuits In Openlane; Provisioning The Router Interface - Paradyne FrameSaver 9783 Installation Instructions Manual

Dsl router

Hide thumbs Also See for FrameSaver 9783:

Table of Contents

Provisioning Data Circuits in OpenLane

Use the OpenLane Provision Circuit screen to add new circuits that start at the

FrameSaver DSL endpoint and traverse the SCM and ATM line card in the Hotwire

GranDSLAM. In addition the default VC sets (from 1 to 4), there is a group of 250 VCs

allocated to each line card that can be assigned to any port on the card. These custom

connections are used to carry the frame relay traffic.

Note that before the custom cross connects are configured, the Maximum VCI

number for the uplink VP to be used by these custom connections must be

specified on the Max VCI per VPI screen and the apply changes executed.

For ATM line cards, custom connections can be used to expand the number of

VCs connected to the card. Each of the 250 VCs can be cross connected from any

VC on the uplink to any port on the line card.

The following information is collected by the Provision Circuit process:

Uplink VPI/VCI

Slot number and Port number of DSL connection

Traffic Profile

DSL link VPI/VCI

Frame relay DLCI (provided by NSP)

Frame relay CIR, B

A Circuit ID is then applied to the newly defined circuit, and stored in both the

FrameSaver DSL unit and in OpenLane.

The FrameSaver DSL 9783 Router defaults to bridge mode. Routing without bridging

and simultaneous routing and bridging are also options.

Use the bridge command from the CLI to configure the bridge and routing attributes.

Also, enter an Ethernet IP address and an DHCP IP address. Refer to the Quick

Reference for a summary of configuration options and CLI default settings.

, B

(provided by NSP)

Table of Contents