Hilti SID 22-A Manual page 13

Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
5.3 Fitting an accessory tool
SID 14­A
SID 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.4 Removing the accessory tool
SID 14­A
SID 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293001 / 000 / 00
11