SMC100CC & SMC100PP
2.0
Prerequisites
EDH0312En1010 – 10/11
2.1
Install LabVIEW 2010
The LabVIEW 2010 from National Instruments must be installed on your computer.
2.2
Download and install Newport NSTRUCT
If the Newport NSTRUCT application is not installed on your computer then download
it from the Newport web site:
Alternatively, the software may be downloaded using Menus as follows:
SALES & SUPPORTS > Softwares & Download > NSTRUCT Software & Applets
2.3
Newport NSTRUCT Server
The Newport NSTRUCT server must be running to communicate with your device.
2.4
Connect your Newport instrument
Before to connect your Newport instrument, read the manual to install its
communication driver. The best way is to follow this manual to install the
communication driver of your Newport instrument.
Single-Axis Motion Controller/Driver for DC or Stepper Motor
http://www.newport.com/NSTRUCT
2