Pairing Button; Software And Utility - Sena Parani-SD1000 User Manual

* Note: You cannot set the Parani-SD1000 to a Baud rate of 1200 and 230K by way of the Dipswitch. If
you want to use them, to set these speeds, please configure the dipswitch to S/W Config setting and
use ParaniWIN or AT
AT+UARTCONFIG,Baudrate,Paraty,Stopbit.

3.8 Pairing Button

Parani-SD1000 provides Pairing Button for instant configuration without a PC to make an automatic
connection between two Parani-SD1000s. In this example we will refer to the two Parani-SD1000s as
SD1 and SD2, respectively. In pairing status, SD changes IAC value automatically (reference C.19).
Step 1. Turn on SD1 and SD2 and Factory reset both of them by pressing Factory Reset Button.
Step 2. Press the Pairing Button of SD1 for 2 seconds until Mode LED blinks 3 times every 3 seconds.
Keep the power ON.
Step 3. Press the Pairing Button of SD2 for 2 seconds until Mode LED blinks 3 times every 3 seconds.
Now press again the Pairing Button for 2 seconds until Mode LED blinks every second.
Step 4. Wait for SD1 & SD2 to connect to each other until the Connect LED' s of SD1 and SD2 blink
every 1 second. It takes about 10 seconds to make a connection. If there are many Bluetooth
devices nearby, it may take longer.
Step 5. Turn SD1 off and on. Mode LED blinks 3 times in green every 3 seconds.
Step 6. Turn SD2 off and on. Mode LED blinks in gr een every second.
Step 7. Now SD1 and SD2 are configured to make automatic connection to each other, whenever they
are powered on.
Using a pair of Parani-SD1000 in this fashion is similar to that of using a wireless serial cable.
* Note: When using the pairing buttons, the Command Response option will be deactivated
automatically. The Parani-SD1000 will not send the response messages such as OK, Connect and
Disconnect.
SD1 Status
1. Factory reset Mode0
2. Push pairing Mode3
button
4. Connected Slave

3.9 Software and Utility

This configuration software and utility for firmware update is included with the product, which also can
be downloaded from http://www.sena.com
Software
ParaniW IN
ParaniUpdater
commands. Please
Table 3-6 Pairing Process by Pairing Button
LED
Mode LED turns on
Mode LED blinks 3
times every 3 seconds
Connect LED blinks
every second
Table 3-7 Configuration Software
Purpose
Configuration
Firmware Update
16
refer to ParaniWIN
SD2 Status
1. Factory res et Mode0
2. Push pairing Mode3
button
3. Push pairing Mode1
button again
4. Connected Master
Operating Syste m
MS Windows 98SE or Higher
MS Windows 98SE or Higher
and Appendix B.3.4
LED
Mode LED turns on
Mode LED blinks 3
times every 3 seconds
Mode LED blinks
every second
Connect LED blinks
every second