Starting And Stopping; Operating The Blower - Stanley SLB- 3IN1 Original Instructions Manual

space to the lower edge to allow the fuel to expand.
(See Fig.5b)
NOTE: Towards the end of the season, it is
advisable to put only as much fuel in the tank as
you need for each cut, so that it is completely used
up before you store the product.
4. Wipe up spilled fuel with a soft cloth and refit the
fuel tank cap.
NOTE: Always dispose of fuel, used oil and objects
contaminated with them in accordance with local
regulations.
OPERATION INSTRUCTIONS
WARNING
1). Stop the engine before:
- cleaning or when clearing a blockage,
- checking, carrying out maintenance or working
on the product,
- leaving the product unattended.
2). Ensure that the product is correctly located in
a designated working position before starting the
engine.
3). While operating the product, always ensure that
the operating position is safe and secure.
4). Do not operate the product with a damaged or
excessively worn suction/blowing device.
5). To reduce fire hazards, keep the engine and
silencer free of debris, leaves and excessive
lubricant.
6). Always use two hands to operate a product
designed with two handles.
7). Always be aware of your surroundings and stay
alert for possible hazards of which you may not be
aware due to the noise of the product.

STARTING AND STOPPING

NOTE: Before starting the unit, make sure all
interlock switches are engaged and
both ON/OFF switches are in the ON(I) position.
To start a cold engine:
Blower should be on a flat, bare surface for
starting.
1. Set two switches on handle to "I" position. (Fig.
6a)
2. Press the primer bulb 5-6 times. Fuel should be
visible in the primer bulb. If it is not, continue to
press the primer until you see fuel in the bulb. (Fig.
6b)
3. Set the choke lever to the "START" position. (Fig.
7)
4. Squeeze the throttle trigger completely and pull
the starter handle until the engine starts.
NOTE: Keep the throttle trigger squeezed
completely.
4. Set the choke lever to the "HALF CHOKE"
position.
5. Pull the starter grip until the engine runs.
NOTE: If the engine does not start, return to the
"FULL CHOKE" position and repeat the process
beginning at step 2.
6. Allow the engine to run for 10-15 seconds, then
set the choke lever to the "RUN" position.
To start a warm engine:
1. Set the choke lever to "RUN" position.
2. Squeeze the throttle trigger completely and pull
the starter handle until the engine starts.
To stop the engine:
To stop the engine, depress the stop switch to the
stop position ("O" position)

OPERATING THE BLOWER

WARNING: Never run the unit without the
blower tubes installed or the air inlet cover
securely closed. Use of an improperly
assembled unit could result in serious personal
injury.
WARNING: Do not place blower on top of or
near loose debris or gravel. Debris may be
sucked into blower intake vent resulting in
possible damage to the unit and could result in
serious personal injury.
WARNING: Always hold the blower away
from your body with the handle in
your right hand when operating, keeping
clearance between your body and the product. As
11
G
B