Installation; Connection - Silvercrest SAR 28 A1 Manual

Installation

Accessories (see rear fold out fl ap)
Figure D:
Case for face plate
29
Installation bracket
30
Key for installation bracket
31
Anchoring plate (including securing material)
32
Installation
WARNING
Damage can be caused when installing the device!
► If possible, have the device installed by a qualifi ed technician.
► If you wish to install the device yourself, follow the instructions for connec-
tion and installation for safe, fault-free use of the device.

Connection

CAUTION
Using incorrect connections can cause damage to the device.
► For installation, use the device's ISO connections. The vehicle-specifi c ISO
adapters you may require can be sourced from a specialist workshop, from
a local dealer or from a general store's technical department. Using other
connector types voids the warranty.
Assignment of the ISO connections
The view of the plug connector is from behind.
SAR 28 A1
ISO A
1 3 5 7
(power supply
2 4 6 8
assignment)
Assignment
1 Not used
2 Not used
3 Not used
Steady plus 12 V
4
(terminal 30)
5 Antenna power
6 Not used
Ignition circuit positive 12 V
7
(terminal 15)
Negative (-)
8
ground (terminal 31)
GB
97