TWM 9000
3.9.3 19" rack-mounted housing (28 TE), electrical connection of the inputs and outputs
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
• For frequencies above 100 Hz, shielded cables are to be used in order to reduce effects from
electrical interferences (EMC).
• Terminal A+ is only operable in the basic version.
Figure 3-24: Terminal compartment for inputs and outputs in rack-mounted housing
1 Shielding
• Connect the conductor to the multipolar plug according to the illustration.
• The signal cable shield is connected to the Pin S.
• Press the plug into the connector.
34-VF-25-53 iss.3 GLO Aug 10 US
ELECTRICAL CONNECTIONS
www.honeywell.com/ps
3
51