Table of Contents
Advertisement
3
Electrical
DC Characteristics
Operating Voltage
Configuration
1
RS232 Only
USB (Full Speed) Only
USB (High Speed) Only
1.At least 3.0V must be maintained at the N56XX input connector during scanning.
2.At least 4.75V must be maintained at the N56XX input connector during scanning.
3.No RS232 option available.
Warning! Do not connect a flex strip to or disconnect a flex strip from the host interface connector when
power is present on the flex strip. This could damage the image engine.
Warning! When using the Micro-B connector, DO NOT apply power through the Flex connector (Pin 2 - Vin).
Doing so can cause harm to either the host or image engine.
Min
Nominal
3.0
3.3
2.3
4.75
5.0
2,3
4.75
5.0
Max
Unit
5.5
V
5.25
V
5.25
V
3 - 1
Advertisement
Table of Contents
