Connection Diagram For Measuring Sensor, 19" Rack-Mounted Housing (28 Te) - Honeywell TWM 9000 Quick Start Manual

ELECTRICAL CONNECTIONS
3

3.5.6 Connection diagram for measuring sensor, 19" rack-mounted housing (28 TE)

DANGER!
The device must be grounded in accordance with regulations in order to protect personnel
against electric shocks.
• If a shielded field current cable is used, the shield must NOT
the signal converter.
• The outer shield of the signal cable is connected in the signal converter housing via the
stranded drain wire.
• Bending radius of signal and field current cable: ≥ 50 mm / 2"
• The following illustration is schematic. The positions of the electrical connection terminals
may vary depending on the housing version.
Figure 3-19: Connection diagram for measuring sensor, 19" rack-mounted housing (28 TE)
1 Electrical terminal compartment in housing of the signal converter for signal and field current cable.
2 Signal cable A
3 Signal cable B
4 Field current cable C
5 Connection box of measuring sensor
6 Functional ground FE
38 www.honeywell.com/ps
NOT be connected in the housing of NOT NOT
34-VF-25-53 iss.3 GLO Aug 10 US
TWM 9000