Table of Contents
Advertisement
For motherboard revision level of 2007, it will be necessary to remove
the Audio Processor / Stereo Generator board, if applicable, to attach
some points onto the motherboard.
Route cable around right side of motherboard and back end of
motherboard to install the wires onto the following locations – see
illustrations below. Colors of cable may not match.
Pin 1 ( Green ) – left side of R46
Pin 2 ( Red ) – left side of R50
Pin 3 ( Blue ) – back side of R9
Pin 4 ( Purple ) – back side of R13
Pin 5 (White ) – right side of R67
Pin 6 ( Black ) – back side of R12
For motherboard revision levels MAR 93 through 2006, route cable
around right side of motherboard and back end of motherboard to
install the wires onto the following locations – see illustration below.
Colors of cable may not match.
Pin 1 – not used – cut stripped end off – if applicable
Pin 2 – not used – cut stripped end off – if applicable
Pin 3 – back side of R11
Pin 4 – back side of R15
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
28
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
