Table of Contents
Advertisement
For motherboard revision levels of 2005 and 2006:
A) Remove front panel assembly (two screws along top left and right
corners and 4 screws along the bottom of the front panel). Remove
the 3 cables that attach to the front panel boards. It is not necessary
to disconnect the Power wires from the switches.
B) Unsolder and remove TP2 and TP5 along the front edge of the
motherboard.
C) Remove the solder from these two points.
D) On the power wire, cut one connector off as close to the connector as
possible (black and red wires).
E) Strip and tin the two open wires.
F) Solder the black wire to TP5 (ground).
G) Solder the red wire to TP2 (+12 V).
H) Replace the front panel assembly.
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
15
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
