Table of Contents
Advertisement
2.2.2 Installing the power connections
Obtain the power wire assembly with the extra header.
For motherboard revision level of 2007:
A) Using solder wick (or your preferred method to remove solder),
remove the solder in the holes of J27, along the front edge of the
motherboard.
B) Remove front panel assembly (two screws along top left and right
corners and 4 screws along the bottom of the front panel).
Remove the 3 cables that attach to the front panel boards. It is not
necessary to disconnect the Power wires from the switches.
C) Install the header onto the motherboard at location J27 - soldering
in place.
D) Replace front panel assembly.
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
14
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
