Table of Contents
Advertisement
If the composite connector will be used, the only other choice of
connectors will be one of the three used for SCA inputs. It is
recommended to use the farthest one from the tuner to avoid
interference with the cabling installation later. This will require that the
SCA board be removed and the parts associated with this connector be
removed as well. Then, the antenna input wire can be soldered directly
to the board once re-installed as shown below.
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
11
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
