Table of Contents
Advertisement
For motherboard revision levels of MAR93 and 2004:
A) On the power wire, cut one connector off as close to the connector as
possible (black and red wires).
B) Strip and tin the two open wires.
C) Solder the black wire to the control/metering board at J1 pins 9 and
10. Care should be taken to avoid melting R67, which is next to the
point of soldering.
D) Solder the red wire to the control/metering board at J1 pins 3 and 4.
Care should be taken to ensure proper soldering with no shorts to
adjacent pads (pins 1 and 2 as well as pins 5 and 6).
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
16
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
