Table of Contents
Advertisement
Plug the control/metering cable into the board as shown based on the
revision of the motherboard. For motherboard revision of 2007, install
cable on J1A with pin 1 (red stripe) toward the center of the unit. All
other motherboard revision levels will install on J1B with pin 1 (red
stripe) toward the center of the unit. It will also be necessary to remove
the keying tab from the cable in order to install the cable onto J1B.
See illustrations below.
Crown Broadcast
2524 Toledo Road
Elkhart, IN 46516
U.S.A.
21
Phone: 574-262-8900
Fax: 574-970-8909
Service: 866-262-8917
service@irec1.com
Advertisement
Table of Contents
