JTECH CommPass Manual page 7

Paging Using a 8205 or 8214 SmartAlert with RS232
and Telephone Transmitter Paging using the
Telephone:
1. Remove the Pager you wish to page from the Charger.
2. The Pager will flash and vibrate to confirm it is
ready for use.
3. The Pager charge LED will continue to flash, confirming
it is ready to receive a page.
4. Pick up the telephone and listen for the dial tone.
5. Dial the telephone number that has been assigned to
the Transmitter.
6. Listen for a beep from the telephone that confirms the
Transmitter is ready.
7. Within 8-10 seconds, use the telephone keypad:
a. Enter the Pager number (up to 4 digits).
b. Press the # key to send the page.
8. A beep will be heard on the telephone that confirms
the message was sent.
9. Hang up the telephone.
10. The Pager will receive a single, one second
vibration (factory setting).
11. See Paging instructions in your Transmitter manual
for more information.
7