Installing Child Restraints Using A Seat Belt (Child Restraint Lock Function Belt); Rear-Facing Baby Seat (Infant Seat)/Child Seat (Convertible Seat) - Toyota Kluger Owner's Manual

Installing child restraints using a seat belt (child restraint lock
function belt)
Rear-facing  Baby seat (infant seat)/child seat (convertible
■
seat)
Fold the seatback while pull-
1
ing the lever. Return the
seatback and secure it at the
1st lock
upright position).
Move the seat as far back as
possible.
Place the child restraint sys-
2
tem on the rear seat facing
the rear of the vehicle.
Run the seat belt through the
3
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
Fully extend the shoulder belt
4
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
position (most
1-1. For safe use
55
1