Power Back Door Operation (Vehicles With A Power Back Door); Power Back Door Operation Using The Entry Function (Vehicles With A Power Back Door); Back Door Closing Assist (Vehicles With A Power Back Door); Jam Protection Function (Vehicles With A Power Back Door) - Toyota Kluger Owner's Manual

118
3-2. Opening, closing and locking the doors
■

Power back door operation (vehicles with a power back door)

●A buzzer sounds and the emergency flashers flash twice to indicate that the
back door is opening/closing.
●The back door can be opened and closed manually even when the power
back door main switch is off.
■
Power back door operation using the entry function (vehicles with a
power back door)
The back door can be opened even if it is locked. All the doors are unlocked
when the power back door is operated. Make sure to lock all the doors again
when you leave the vehicle. The doors will not lock automatically after the
back door has been closed.
■

Back door closing assist (vehicles with a power back door)

If the back door is lowered manually when the back door is stopped at an
open position, the back door will fully close automatically.
■

Jam protection function (vehicles with a power back door)

●If anything obstructs the power back door while it is closing, the back door
will open slightly then stop.
●If anything obstructs the power back door while it is opening, the back door
will immediately stop.
■
Fall-down protection function (vehicles with a power back door)
While the power back door is opening automatically, applying excessive force
to it will stop the opening operation to prevent the power back door from sud-
denly shutting.
■
Canceling the adjusted open position of the back door (vehicles with a
power back door)
Press and hold the power back door switch on the back door until a buzzer
sounds 4 times, pauses momentarily, and then sounds 2 times. The open
position is initialized to the fully opened position.
■
When reconnecting the battery or changing a fuse while the back door is
open (vehicles with a power back door)
To enable the power back door to operate properly, initialize the system by
completely closing the back door manually. If the battery is reconnected or a
fuse is changed while the back door is closed, initializing the system is not
necessary.
■
Customization (vehicles with a power back door)
Settings (e.g. power back door opening angle) can be changed.
(Customizable features: →P. 462)