Turning Off Both Trc And Vsc Systems; When The Message Is Displayed On The Multi-Information Display Showing That Trc Has Been Disabled; Sounds And Vibrations Caused By The Abs, Brake Assist, Trc, Vsc And Hill-Start Assist Control Systems; Automatic Reactivation Of Trc And Vsc Systems - Toyota Kluger Owner's Manual

■

Turning off both TRC and VSC systems

To turn the TRC and VSC systems off, press and hold
seconds while the vehicle is stopped.
The VSC OFF indicator light will come on and the "TRC OFF" will be shown
on the multi-information display.
Press again to turn the systems back on.
*
: On vehicles with pre-crash safety system, pre-crash brake assist and pre-
crash braking will also be disabled. The pre-crash safety system warning
light will come on and the message will be shown on the multi-information
display. (→P. 260)
■
When the message is displayed on the multi-information display show-
ing that TRC has been disabled even if
TRC, hill-start assist control and downhill assist control cannot be operated.
Contact your Toyota dealer.
■
Sounds and vibrations caused by the ABS, brake assist, TRC, VSC and
hill-start assist control systems
●A sound may be heard from the engine compartment when the brake pedal
is depressed repeatedly, when the engine is started or just after the vehicle
begins to move. This sound does not indicate that a malfunction has
occurred in any of these systems.
●Any of the following conditions may occur when the above systems are
operating. None of these indicates that a malfunction has occurred.
• Vibrations may be felt through the vehicle body and steering.
• A motor sound may be heard after the vehicle comes to a stop.
• The brake pedal may pulsate slightly after the ABS is activated.
• The brake pedal may move down slightly after the ABS is activated.
■
EPS operation sound
When the steering wheel is operated, a motor sound (whirring sound) may be
heard. This does not indicate a malfunction.
■

Automatic reactivation of TRC and VSC systems

After turning the TRC and VSC systems off, the systems will be automatically
re-enabled in the following situations:
●Vehicles without a smart entry & start system: When the engine switch is
turned to the "LOCK" position.
Vehicles with a smart entry & start system: When the engine switch is
turned off
●If only the TRC system is turned off, the TRC will turn on when vehicle
speed increases
If both the TRC and VSC systems are turned off, automatic re-enabling will
not occur when vehicle speed increases.
4-5. Using the driving support systems
*
has not been pressed
255
for more than 3
4