Removing The Ccd - Clevo N850HK1 Service Manual

Disassembly

Removing the CCD

Figure 9
CCD Removal
1. Turn off the computer, turn it over to remove the battery
2. Lay the computer down on a flat surface with the top case up forming a 90 degree angle. Carefully remove the
a. Remove rubber and
rubber covers
screws and then careful-
3. Run your fingers around the inner frame of the LCD panel to lift at the upper point
ly release the inner
and slightly push and lift up the inner frame at the middle points
frame of the LCD panel
your fingers around the inner frame at the lower point
at the points indicated by
4. Remove the LCD front cover
the arrows.
b. Remove the LCD front
cover.
a.
b.

9. LCD Front Cover
• 2 Screws
2 - 14 Removing the CCD
- and screws
1 2 3
(Figure
5
3
1
(page 2 - 5).
- .
4
-
6 7
as indicated by the arrows
8
9b).
6
2
4
9
as indicated by the arrows,
5
as indicated by the arrows, and then run
(Figure 9a).
5
7
8