Removing The Keyboard - Clevo N850HK1 Service Manual

Disassembly

Removing the Keyboard

Figure 2
Keyboard Removal
1. Turn off the computer, turn it over.
2. Remove screws
a. Remove the screws from
3. Open it up with the LCD on a flat surface before pressing at point
the bottom of the compu-
cial eject stick
ter and then eject the
4. Carefully lift the keyboard
keyboard using a special
board ribbon cable
eject stick to push the
away from the base
keyboard out while re- 8
leasing the keyboard as 5. Carefully lift the keyboard
shown.
b. Lift the keyboard up and
a.
disconnect the keyboard
ribbon cable from the
locking collar socket.
c. Remove the keyboard.

Re-inserting the Key-
board
When re-inserting the
keyboard firstly, align the
keyboard tabs at the bot-
tom of the keyboard with
the slots in the case.

4. Eject Stick
4
6. Keyboard
• 2 Screws
2 - 6 Removing the Keyboard
- from the bottom of the computer.
1 2
to do this) while releasing the keyboard in the direction of the arrow
4
up, being careful not to bend the keyboard ribbon cable
6
from the locking collar socket by using a flat-head screwdriver to pry the locking collar pins
7
(Figure 2b).
off the computer
6
1
2
5
3
to release the keyboard module (use the spe-
3
(Figure 2c).
b.
6
c.
6
as shown (Figure 2a).
5
. Disconnect the key-
7
7
8 8