Removing The Ccd - Clevo N860EK1 Service Manual

Removing the CCD

1. Turn off the computer, turn it over to remove the battery
2. Lay the computer down on a flat surface with the top case up forming a 90 degree angle.
3. Run your fingers around the inner frame of the LCD panel to lift at the upper point
Lift the outer frame at the middle points
4. Remove the LCD front cover
a.
1
2
4
b.
(page 2 -
- as indicated by the arrows
2 4
(Figure 8b).
5
3
5
5).
as indicated by the arrows.
1
(Figure 8a).
Disassembly
Figure 8
CCD Removal
a. Remove rubber and
screws. Then carefully
release the inner frame
of the LCD panel at the
points indicated by the
arrows.
b. Remove the LCD front
cover.

5. LCD Front Cover
Removing the CCD 2 - 13