Network - D-Link DSL-2888A User Manual

Section 4 - Configuration
This section will allow you to change the local network settings of the router and to configure
the DHCP settings. In the Settings menu on the bar on the top of the page, click Network.
Click Advanced Settings... to expand the list and see all of the options.
Network Settings
LAN IP Address:
Enter the IP address of the router for this interface. The default IP
address is 192.168.1.1.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
configuration utility.
Subnet Mask: Enter the subnet mask of this interface. The default subnet mask is
255.255.255.0.
Local Domain
Enter the domain name (optional).
Name:
Enable DNS Relay: Disable for devices on your network to perform DNS lookups directly
with your ISP. If enabled, your computers will use the router as a DNS
server.
Advanced Settings - DHCP Server
Status:
Enable or disable the DHCP server.
DHCP IP Address
Enter the starting and ending IP addresses for the DHCP server's IP
Range: assignment.
Note: If you statically (manually) assign IP addresses to your computers
or devices, make sure the IP addresses are outside of this range or you
may have an IP conflict.
D-Link DSL-2888A User Manual

Network

Home Settings
DSL-2888A HW:V1.0.0 FW:V1.1.43
Network
Use this section to configure the network settings for your device. You can enter a name for your device in
the management link field, and use the link to access web UI in a web browser. Recommend to change the
management link if there are more than one D-Link devices within the network.
Settings >> Network
Network Settings
LAN IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Local Domain Name: localhost
Enable DNS Relay: Enabled
DHCP Server
Enabled
Status:
DHCP IP Address Range: 192.168.1. 100 to 192.168.1.
DHCP Lease Time: 86400 minutes
Advanced Settings
IPv4 Multicast Streams: Enabled
IPv6 Multicast Streams Enabled
IPv6 Settings
WAN Interface: Eth0
My Internet Connection is: Auto Configuration (SLAAC/DHCPv6)
LAN IPv6 ADDRESS SETTINGS
Enable DHCP-PD: Enabled
LAN IPv6 Link-Local Address: fe80::1
ADDRESS AUTOCONFIGURATION SETTINGS
Enable Automatic IPv6 Address Assignment: Enabled
Autoconfiguration Type: Stateful DHCPv6
IPv6 Advertisement Lifetime: minutes
COPYRIGHT © 2016 D-Link
Features Management
Save
Advanced Settings ...
254
⌵
Advanced Settings ...
⌵
44