Ipv6 - D-Link DSL-2888A User Manual

Section 4 - Configuration
To configure IPv6 rules, on the Static Routes page click IPv6. To return to the main IPv4 static
routes page, click IPv4.
If you wish to remove a rule, click on its trash can icon in the Delete column. If you wish
to edit a rule, click on its pencil icon in the Edit column. If you wish to create a new rule,
click the Add Rules button. Click Save when you are done. If you edit or create a rule, the
following options will appear:
Create New Rule
DestNetwork:
This is the IP address of the router used to reach the specified
destination.
PrefixLen: Enter the IPv6 address prefix length of the packets that will take this
route.
Gateway:
Enter your next hop gateway to be taken if this route is used.
Metric:
Enter the metric value for this rule here.
Interface:
Select the interface that the IP packet must use to transit out of the
router when this route is used.
Click Apply and Save when you are done.
D-Link DSL-2888A User Manual

IPv6

DSL-2888A HW:V1.0.0
Features >> Static Routes >> IPv6
Status
Add Route
Create New Route
Home Settings Features
FW:V1.1.43
Static Routes
Once connected to the Internet, your router automatically builds routing tables that determine where traffic
should be sent. Static routes can override this process, allowing traffic to be directed to a specific client or
location.
DestNetwork PrefixLen Gateway Metric
Remaining: 24
COPYRIGHT © 2016 D-Link
DestNetwork:
PrefixLen:
Gateway:
Metric:
⌵
Interface: Eth0
Apply
Management
IPv4 Save
Interface Edit Delete
54